Veteran Garage Door Repair | Keller TX | 817-769-8488

Garage Door Opener Repair

You may discover that your garage door opener has actually been providing you problems, so you require to repair it. You can repair it by replacing a circuit board, a photo-eye sensing unit, the major drive equipment, or the set-limit switches. You can likewise inspect if the safety and security sensors are working properly.

Changing a motherboard

Changing a circuit card for your garage door opener requires a few steps and tools. Initially, you need to turn off the breaker and disconnect any wires. Next, open the circuit board cover. This will assist you to identify the trouble as well as establish if you need a new board. Next, get rid of the old board and also its cord connectors.

You can then proceed to replace the motherboard. The replacement procedure is easy and takes about 10 minutes. A new circuit board will cost concerning $80. To shield your new circuit card from power surges, you can purchase a surge protector.

Changing a photo-eye sensing unit

Changing a photo-eye sensor can be a relatively simple task. First, remove the sensor from the door as well as see to it is located correctly. If the sensor is angled in any way, it might not be receiving the right signal, which could be creating the blinking lights. If you notice that the photo-eyes run out positioning, you might need to have actually a service technician come as well as take care of the problem.

The photo-eye sensor contains two items that install outside of the door tracks and also towards the floor. The picture eyes will certainly have a tiny LED light as well as need to be solid in shade. If the light is blinking, its most likely the photo-eye is malfunctioning and will certainly require to be changed.

Changing a major drive equipment

To replace a garage door opener primary drive gear, start by getting rid of the cap from the chain pulley. Next, get rid of both screws holding the drive gear to the gear assembly. Now, you can loosen the three tension pins. Press them from both sides and afterwards remove them. Then, separate the three cables from the garage door opener motor. These wires should be white, red, as well as blue.

Once you have actually removed the old gear, set up a new one. Be sure to grease it well. Place the new equipment right into the shaft, seeing to it to line up the mounting openings. Ensure the equipment and gear setting up are located appropriately to make sure smooth procedure. Next off, make use of a hammer as well as a nail to drive a pin right into the new gear.

Readjusting the set-limit switches

The first point you must do if your garage door is not working appropriately is to inspect the set-limit switches. You may need to change them to make sure that the door closes earlier or stops prior to it reaches the flooring. You can inspect this by checking out your garage doors manual or online.

To readjust the set-limit switches, youll require a screwdriver or outlet. Adjust the knob clockwise or counterclockwise up until the door moves up and also stops, or lowers its distance. To look for appropriate traveling distance, gauge the void from the bottom of the garage door to the ground.

Veteran Garage Door Repair – Keller

204 S Key St Ste 105, Keller, TX 76248, United States

817-769-8488

https://veterangaragedoor.com/veteran-garage-door-repair-of-keller-tx/


Garage Door Repair


Garage Door Installation


Garage Door Company


Garage Door Service


Garage Door Opener Repair

Veteran Garage Door Repair

204 S Main St Ste 105
Keller,TX
76248
817-769-8488

Leave a Reply

Your email address will not be published. Required fields are marked *


Back To Top